CMA157886CX1000HR
PC/104-Plus Single Board Computer & Controller
1.0 GHz Intel® Celeron® M
Key Features
¤ |
PC/104 form factor |
¤ |
PC/104-Plus Stackable Bus Structure |
¤ |
Complete PC-compatible Single Board Computer (SBC)
|
¤ |
Intel Pentium M 1.40 GHz Processor on 90nm |
¤ |
Thermal throttling
|
¤ |
Nonvolatile storage of CMOS settings without battery |
¤ |
Stackable 120-pin PCI bus |
|
◆ |
4 Bus master add-on cards capable |
¤ |
256 Mbytes BGA DDR SDRAM (Surface-Mounted) |
|
◆ |
Up to 333 MHz Data Rate |
¤ |
32-pin SSD socket: |
|
◆ |
Removable Onboard Miniature Industrial ATA/IDE Flash Disk up to 8GB (4GB Standard) |
|
◆ |
Flash Disk PIO Mode with BIOS-configured write protect function (available upon request) |
|
◆ |
Natively supported by all major operating systems |
¤ |
BIOS Selectable 14-bit Digital I/O with Advanced Digital Interrupt Modes with Ground and +5 VDC |
¤ |
10/100 Ethernet with PXE Network Boot |
¤ |
Four RS-232/422/485 Ports |
¤ |
Four USB 2.0 (Universal Serial Bus) Ports |
¤ |
EIDE Controller with UltraDMA 100 |
¤ |
855GME SVGA controller Onboard with 3D Acceleration |
¤ |
DirectX & OpenGL 3D Accelerator |
¤ |
Advanced power management features including Enhanced Intel SpeedStep Technology |
¤ |
Advanced Thermal Management |
|
◆ |
Thermal Throttling reduces clock speed to prevent thermal runaway |
|
◆ |
Auto Fan Control only runs fan when needed |
|
◆ |
SMBus Temperature Monitor for CPU and board temperature |
|
◆ |
Mini Fan Heatsink with Auto Fan control |
|
◆ |
Passive Structural Heatsink & Heatpipes in IDAN and HiDAN System Configurations |
¤ |
Advanced Programmable Interrupt Controller (APIC) |
¤ |
24 interrupt channels with APIC enabled (15 in legacy PIC mode) |
¤ |
3 timer/counter channels |
¤ |
High resolution 100 MHz APIC timer |
¤ |
RTD Enhanced BIOS with ACPI, USB Boot and Quick Boot modes |
¤ |
Advanced Configuration and Power Interface (ACPI) |
|
◆ |
ACPI 1.0 Compliant |
|
◆ |
Supported power down modes: S1 (Power On Suspend), S3 (Suspend to RAM), S4 (Hibernate), and S5 (Soft-Off) |
|
◆ |
CPU Clock Throttling and Clock Stop for C0 to C3 Support |
|
◆ |
Also supports APM 1.2 for legacy power management |
¤ |
3.3V or 5V PCI bus signaling |
¤ |
400 MHz, source-Synchronous Front Side Bus |
¤ |
Supports MMX and SSE2 instructions |
¤ |
Math coprocessor |
¤ |
Internal Cache |
|
◆ |
L1 - 32KB of instruction and 32KB data; L2 - 2MB |
¤ |
Y2K compliant real time clock (external battery required) |
¤ |
Watchdog timer |
¤ |
PS/2 Mouse Port |
¤ |
Keyboard Port |
¤ |
Speaker Port |
|
|
|
|
|
|
|
Technical Details
- Fast Ethernet
- Ethernet Controller
- Intel 82562 Fast Ethernet PCI Controller
- Integrated 3KByte Transmit and 3Kbyte Receive FIFOs
- Physical Layer
- 100Base-Tx and 10Base-T
- Full Duplex support
- Easy to Use
- Low Power Features
- LED Status
- Software configuration
- 855GME SVGA controller for CRT and LVDS Flat Panel
- Analog SVGA Output
- LVDS Flat Panel output
- Resolution up to 2048 x 1536 pixels with 32K colors
- VGA, SVGA, XGA, SXGA, UXGA
- Up to 16 million colors
- 64-bit AGP Hardware graphics-accelerator
- 2MB to 64MB of shared SDRAM high-performance memory
- Four BIOS configurable RS-232/422/485 serial ports on two
connectors, each connect configurable as:
- One full RS-232 port with TxD, RxD, CTS, RTS, DSR, DTR,
RI, and CD
- One RS-422/485 port with TxD+, TxD-, RxD+, RxD-, with
120 ohm termination jumper
- Two RS-232 ports:
- One with TxD, RxD, CTS, and RTS
- One with TxD and RxD
- One RS-232 port with TxD and RxD, and one RS-422/485
port with TxD+, TxD-, RxD+, RxD-, with 120 ohm termination
jumper
- Jumper enabled two RS-422/485 ports each with TxD+, TxD-,
RxD+, RxD-, with 120 ohm termination jumper
- 16550 compatible UARTs for high-speed
- 14 Advanced Digital I/O (aDIO)
- One 8-bit-programmable I/O with Advanced Digital
Interrupt Modes
- Event Mode Interrupt generates an interrupt when any
input bit changes
- Match Mode Interrupt generates an interrupt when
input bits match a preset value
- External Strobe Mode latches 8 data inputs and
generates and interrupt
- One 4-bit port programmable as input or output
- Two Strobes can be configured as readable inputs.
- Four USB 2.0 (Universal Serial Bus) Ports
- High-speed, full-speed, or low-speed
- 500 mA @ 5 Vdc provided per port
- USB Boot capability
- UltraDMA-100 / 66 / 33 Master Mode PCI EIDE Controller
- Transfer rate up to 100MB/sec using UltraDMA
- Increased reliability using UltraDMA-33 transfer
protocols
- Support ATAPI compliant devices including DVD drives
- 48-bit LBA support for hard drives larger than 137GB
- Utility port
- XK-CM77 Cable Kit Included
- PC-AT compatible keyboard port
- PS/2 Mouse Port
- Speaker (0.1W output) port
- Hardware Reset input
- Battery input for Real Time Clock
- Power I/O
- Access to PC/104 Bus power pins
- Access to PC/104-Plus Bus pins
- ISA Expansion Bus
- Full ISA bus operation.
- Supports 8-bit (XT) and 16-bit (AT) peripherals.
- All ISA IRQ lines and DMA channels supported.
- Supports both I/O-mapped and Memory-mapped expansion
cards.
- Subtractive Decode of PCI cycles
- Existing software can be used without modification.
- No special setup required.
- Mating Connectors
- Standard 12-pin 0.1" DIL header (Power)
- Standard 10-pin 0.1" DIL header (Utility, COM1,
COM2, USBs, Ethernet)
- Standard 10-pin 2mm DIL header (SVGA)
- Standard 20-pin 2mm DIL header (Panel)
- Standard 16-pin 0.1" DIL header (aDIO)
- Standard 44-pin 2mm DIL header (EIDE)
Software
- RTD Enhanced BIOS
- Supports boot from IDE, USB, or Ethernet (PXE)
- Serial Console Redirection
- Flash-based CMOS Setup – No battery required to store
settings
- Fail Safe Boot – Load DOS even if no boot device is
present
- Special RTD Reliability Enhancements
- Compatible with all x86 PC operating systems:
- DOS (MS-DOS, ROM-DOS, PC-DOS)
- Windows (XP, XP Embedded)
- Linux (desktop and real-time versions)
- RTOSes such as QNX, VxWorks, Windows CE, and xPC Target
- Note: Some hardware interfaces may require special
drivers
- Includes pre-installed Datalight ROM-DOS
- Drivers and support provided for DOS, Windows, and Linux
Physical Attributes
- Dimensions
- Board Size
- Length (L): 3.775 inches (95.89 mm)
- Width (W): 3.550 inches (90.17 mm)
- Stand-off Height: 0.600 inches (15.24 mm)
- I/O Extension
- Length (EL): 3.125 inches (79.375 mm)
- Width (EW): 0.500 inches (12.700 mm)
- Weight: Approximately 0.40 lbs. (0.19 Kg) with heat sink
- Standard Operating Temperature: -40 to +85°C, 90% humidity
non-condensing
- Storage Temperature: -40 to +85°C
- Power Consumption: 11.9 W @ 5 V Typical
Recommended Accessories
- Cable Kit XK-CM90
- BRG1825: PCI to PCI Express Bridge
Part Number |
Description |
CMA157886CX1000HR-256 |
1.0 GHz PC/104-Plus cpuModule with 256MB DDR SDRAM & 4GB Flash Drive |
|
|
TEL:027-82702749,82702750
FAX:027-82702769 |