当前位置:首页 >> PC/104模块板 >> CPU模块板 >> Pentium M处理器系列 >> 


 

CMX158886PX1400HR

 

PCI-104 Single Board Computer & Controller

1.40 GHz Intel® Pentium® M


 

Key Features


 

¤

PC/104 form factor
¤ PCI-104 Stackable Bus Structure
¤

Complete PC-compatible Single Board Computer (SBC)

¤

Available in stackable, rugged enclosures

¤ Intel Pentium M 1.40 GHz Processor on 90nm
¤ Thermal throttling
¤ Nonvolatile storage of CMOS settings without battery

¤

Stackable 120-pin PCI bus
4 Bus master add-on cards capable
¤ 512 Mbytes BGA DDR SDRAM (Surface-Mounted)

Up to 333 MHz Data Rate

¤

32-pin SSD socket:
Removable Onboard Miniature Industrial ATA/IDE Flash Disk up to 8GB (4GB Standard)
Flash Disk PIO Mode with BIOS-configured write protect function (available upon request)
Natively supported by all major operating systems
¤ multiPort with Parallel Port, Floppy Drive Interface and 18-bit Digital I/O Port with Advanced Digital Interrupt Modes

¤

10/100 Ethernet with PXE Network Boot
¤ Four RS-232/422/485 Ports
¤ Two USB 2.0 (Universal Serial Bus) Ports
¤ EIDE Controller with UltraDMA 100
¤ 855GME SVGA controller Onboard with 3D Acceleration
¤

DirectX & OpenGL 3D Accelerator

¤

Advanced power management features including Enhanced Intel SpeedStep Technology

¤

Advanced Thermal Management

Thermal Throttling reduces clock speed to prevent thermal runaway
Auto Fan Control only runs fan when needed
SMBus Temperature Monitor for CPU and board temperature
Mini Fan Heatsink with Auto Fan control
Passive Structural Heatsink & Heatpipes in IDAN and HiDAN System Configurations
¤ Advanced Programmable Interrupt Controller (APIC)
¤ 24 interrupt channels with APIC enabled (15 in legacy PIC mode)
¤ 3 timer/counter channels
¤ High resolution 100 MHz APIC timer
¤ RTD Enhanced BIOS with ACPI, USB Boot and Quick Boot modes
¤ Advanced Configuration and Power Interface (ACPI)
ACPI 1.0 Compliant
Supported power down modes: S1 (Power On Suspend), S3 (Suspend to RAM), S4 (Hibernate), and S5 (Soft-Off)
CPU Clock Throttling and Clock Stop for C0 to C3 Support
Also supports APM 1.2 for legacy power management
¤ 3.3V or 5V PCI bus signaling
¤ 400 MHz, source-Synchronous Front Side Bus
¤ Supports MMX and SSE2 instructions
¤ Math coprocessor
¤ Internal Cache
L1 - 32KB of instruction and 32KB data; L2 - 2MB
¤ Y2K compliant real time clock (external battery required)
¤ Watchdog timer
¤ PS/2 Mouse Port
¤ Keyboard Port
¤ Speaker Port

  

   

 

 

 

Technical Details

  • Fast Ethernet
    • Ethernet Controller
      • Intel 82562 Fast Ethernet PCI Controller
      • Integrated 3KByte Transmit and 3Kbyte Receive FIFOs
    • Physical Layer
      • 100Base-Tx and 10Base-T
      • Full Duplex support
    • Easy to Use
      • Low Power Features
      • LED Status
      • Software configuration
  • 855GME SVGA controller for CRT and LVDS Flat Panel
    • Analog SVGA Output
    • LVDS Flat Panel output
    • Resolution up to 2048 x 1536 pixels with 32K colors
    • VGA, SVGA, XGA, SXGA, UXGA
    • Up to 16 million colors
    • 64-bit AGP Hardware graphics-accelerator
      • 2MB to 64MB of shared SDRAM high-performance memory
  • Four BIOS configurable RS-232/422/485 serial ports on two connectors, each connect configurable as:
    • One full RS-232 port with TxD, RxD, CTS, RTS, DSR, DTR, RI, and CD
    • One RS-422/485 port with TxD+, TxD-, RxD+, RxD-, with 120 ohm termination jumper
    • Two RS-232 ports:
      • One with TxD, RxD, CTS, and RTS
      • One with TxD and RxD
    • One RS-232 port with TxD and RxD, and one RS-422/485 port with TxD+, TxD-, RxD+, RxD-, with 120 ohm termination jumper
    • Jumper enabled two RS-422/485 ports each with TxD+, TxD-, RxD+, RxD-, with 120 ohm termination jumper
    • 16550 compatible UARTs for high-speed
  • multiPort function connector
    • Parallel port
      • SPP, PS/2 bi-directional, EPP & ECP
    • Advanced Digital I/O (aDIO)
      • One 8-bit port programmable as input or output
      • Eight bit-programmable I/O with Advanced Digital Interrupt Modes
        • Event Mode Interrupt generates an interrupt when any input bit changes
        • Match Mode Interrupt generates an interrupt when input bits match a preset value
        • External Strobe Mode latches 8 data inputs and generates and interrupt
      • Two Strobes can be configured as readable inputs.
    • Floppy controller interface - Requires RTD's XK-CM49 multiPort Floppy Drive and Cable Kit
  • Two USB 2.0 (Universal Serial Bus) Ports
    • High-speed, full-speed, or low-speed
    • 500 mA @ 5 VDC provided per port
    • USB Boot capability
  • UltraDMA-100 / 66 / 33 Master Mode PCI EIDE Controller
    • Transfer rate up to 100MB/sec using UltraDMA
    • Increased reliability using UltraDMA-33 transfer protocols
    • Support ATAPI compliant devices including DVD drives
    • 48-bit LBA support for hard drives larger than 137GB
  • Utility port
    • XK-CM77 Cable Kit included
    • PC-AT compatible keyboard port
    • PS/2 Mouse Port
    • Speaker (0.1W output) port
    • Hardware Reset input
    • Battery input for Real Time Clock
  • Power I/O
    • Access to PCI-104 Bus pins
      • Gnd, ±12, 5 & 3.3 VDC
  • Mating Connectors
    • Standard 12-pin 0.1" DIL header (Power)
    • Standard 10-pin 0.1" DIL header (Utility, COM1, COM2, USB, Ethernet)
    • Standard 10-pin 2mm DIL header (SVGA)
    • Standard 20-pin 2mm DIL header (Panel)
    • Standard 26-pin 0.1" DIL header (multiPort)
    • Standard 44-pin 2mm DIL header (EIDE)
       

Software

  • RTD Enhanced BIOS
    • Supports boot from IDE, USB, or Ethernet (PXE)
    • Serial Console Redirection
    • Flash-based CMOS Setup – No battery required to store settings
    • Fail Safe Boot – Load DOS even if no boot device is present
    • Special RTD Reliability Enhancements
  • Compatible with all x86 PC operating systems:
    • DOS (MS-DOS, ROM-DOS, PC-DOS)
    • Windows (XP, XP Embedded)
    • Linux (desktop and real-time versions)
    • RTOSes such as QNX, VxWorks, Windows CE, and xPC Target
    • Note: Some hardware interfaces may require special drivers
  • Includes pre-installed Datalight ROM-DOS
  • Drivers and support provided for DOS, Windows, and Linux
     

Physical Attributes

  • Dimensions
    • Board Size
      • Length (L): 3.775 inches (95.89 mm)
      • Width (W): 3.550 inches (90.17 mm)
    • I/O Extension
      • Length (EL): 3.125 inches (79.375 mm)
      • Width (EW): 0.500 inches (12.700 mm)
  • Weight: Approximately 0.40 lbs. (0.19 Kg) with heat sink
  • Standard Operating Temperature: -40 to +85°C, 90% humidity non-condensing
  • Storage Temperature: -40 to +85°C
  • MTBF
    • CMX158886PX1400HR-512:  329,293 hours
  • Power Consumption: 12.7 W @ 5 V Typical
     

Recommended Accessories

  • Cable Kit XK-CM88
  • BRG1825: PCI to PCI Express Bridge

 

Part Number Description
CMX158886PX1400HR-512 PCI-104 cpuModule with 512MB SDRAM

 

 

 TEL027-8270274982702750   FAX027-82702769